Configuration Problem : announce default route via ospf

[RR]

> Hello
>
> I don't see any problem, your config works for me (without the obvious
> typo of missing semicolon in filter export_OSPF), default route is exported
> in both 1.3.9 and 1.3.6 (default route could be seen in both 'show ospf state'
> and 'show ospf lsadb').
I use bird-1.3.7 from openbsd ports
> There were some bugs in pre-1.3.9 that causes default route to disappear
> or does not allow to export routes to OSPF, but they were all related
> to configurations with multiple areas.
No multiple areas here.
> Your config would not work if there is already one default route in OSPF domain,
> it would be imported to main routing table and blocks exporting the default
> route from kernel protocol (because of higher default priority of OSPF routes),
> but this you could see in 'show route'.
Ah that's the point. I've already got a default route announced by 
another route, but this is what I want.
In my setup I want both router advertise the default and play on metric.

bird> show route
0.0.0.0/0          via 192.168.0.1 on vr0 [ospf1 21:09] * E2 (150/15/80) 
[0.0.0.1]
                    via 81.220.124.1 on vr1 [kernel1 21:09] (10)
bird> show ospf state

         router 0.0.0.1
                 distance 5
...
                 external 0.0.0.0/0 metric2 80 via 82.243.43.254

> You could try to change export in OSPF to 'export all', try to replace
> kernel default route with static default route, or you could change area
> in OSPF to 0.0.0.0 (backbone) to see what your problem is related to.
>
I've tried export all with no success. But my problem is clearly related 
to an already default in ospf.

So what your advise ? Can I filter the default advertise by another 
router ? play with metric ?

-- 
Raphael Mazelier