problems with simple configuration

[Ondrej Filip]

On 9 Apr 2001, David Rohleder wrote:

>
> Hello,
>
> i have got a simple config, which behaves badly:
>
>  Internet           P-t-P netw.    local network
> ------------| VNR |----------| R |-------------
>
>
> ---[/etc/bird.conf
>
> debug protocols all;
>
> protocol direct {
> #       interface "-eth*", "*"; # Restrict network interfaces it works with
> }
>
> protocol kernel {
> #       learn;                  # Learn all alien routes from the kernel
>         persist;                # Don't remove routes on bird shutdown
>         scan time 20;           # Scan kernel routing table every 20 seconds
> #       import none;            # Default is import all
>         export all;             # Default is export none
> #       kernel table 5;         # Kernel table to synchronize with (default: mai
> n)
> }
>
> protocol static {
> }
>
> protocol rip MyRIP {    # You can also use an explicit name
>         port 520;
>         interface "eth2" { mode broadcast; };
>         authentication none;
>         import none;
>         export all;
> }
>
> protocol ospf MyOSPF {
>         # rfc1583compat yes;
>         area 0.0.0.2 {
>         #       stub no;
>         #       tick 1;
>                 interface "eth0" {
>                         cost 500;
>                         dead count 4;
>                         type broadcast;
>                 };
>                 interface "eth1" {
>                         cost 500;
>                         dead count 4;
>                         type broadcast;
>                 };
>                 interface "eth2" {
>                         stub yes;
>                         cost 10;
>                 };
>                 interface "eth3" {
>                         stub yes;
>                         cost 10;
>                 };
>         };
> }
>
> ------[/etc/bird.conf
>
> eth1 and eth3 are up, but there are not any machines. eth3 doesn't
> have IP address.
>
>
> After start, VNR (Bay Networks) doesn't see internal network. But they
> are in full state!
>
> And even more strange thing: VNR learns LSA after some action in
> birdc. For example, when i run debug MyOSPF all, or even just start birdc!
>
> May be some timing problems. It is PIII/600, 128MB RAM.
>
> some strange messages:
>
> MyOSPF: LS ack sent to 147.251.61.1 (delayed)
>
> shows every max. 20 sec.

Hmm it's very strange. :-( Please could you tell me what says 'show ospf'
and other 'show ospf *'?

>
>
> 147.251.61.0/30 is P-t-P link.
>
> I have got BIRD 1.0.4 with OSPF area patch.
>
>
> Please, release 1.0.5 as soon as possible. Or at least publish all patches.
>

OK, I'll try it.

>
>
>