How to export prefixes configured on loopback via OSPF

[Madhuri]

Hi,

How to export prefixes configured on loobback interfaces through OSPF.
working fine with BGP.

following is the configuration that I have tried.
But 192.168.1x.1 are not shown in neighbor's route table.

Thanks in advance.

*ifconfig output :*

lo:11     Link encap:Local Loopback
          inet addr:192.168.11.1  Mask:255.255.255.0
          UP LOOPBACK RUNNING  MTU:65536  Metric:1

lo:12     Link encap:Local Loopback
          inet addr:192.168.12.1  Mask:255.255.255.0
          UP LOOPBACK RUNNING  MTU:65536  Metric:1

*bird.conf*

router id 1.1.1.1;

protocol direct {
        interface "eth1","eth2","lo*";
}

protocol kernel {
        persist;
        scan time 20;
        export all;
}

protocol device {
        scan time 10;
}

protocol ospf R1 {
        tick 2;
        rfc1583compat yes;
        area 0.0.0.0 {
                stub no;
                interface "eth1","eth2" {
                        hello 9;
                        retransmit 6;
                        cost 10;
                        transmit delay 5;
                        dead count 5;
                        wait 50;
                        type broadcast;
                        authentication simple;
                        password "admin";
                };
        };
}



Thanks,
Madhuri
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://trubka.network.cz/pipermail/bird-users/attachments/20150611/5520c4af/attachment.html>