bird as route-server

[Harald Michl]

Hi!
I'm new to the list and new to bird, but know a little bit about bgp  
and what i want:

I want to use bird as a route-server in an ixp environment. If I  
configure a peer as rc client, i get a syntax-error at "rs client;".  
The config command should exist according to the documentation... I  
append the peer-config. Has anyone a hint?
I use Version 1.0.11-4.

thanks for your answers,
Harald



protocol bgp AS64002 {
         local as 64000;
         neighbor 10.203.0.2 as 64002;
         rs client;
         hold time 240;
         startup hold time 240;
         connect retry time 120;
         keepalive time 80;      # defaults to hold time / 3
         start delay time 5;     # How long do we wait before initial  
connect
         error wait time 60, 300;# Minimum and maximum time we wait  
after an error (when consecutive
                                 # errors occur, we increase the delay  
exponentially ...
         error forget time 300;  # ... until this timeout expires)
         next hop self;          # Disable next hop processing and  
always advertise our local address as nexthop
         path metric 1;          # Prefer routes with shorter paths  
(like Cisco does)
         default bgp_med 0;      # MED value we use for comparison  
when none is defined
         default bgp_local_pref 100;     # The same for local preference
         source address 10.203.0.254;    # What local address we use  
for the TCP connection
         export all;
}


--
  Harald Michl                <harald.michl at univie.ac.at>
  Vienna University - ACOnet www.ACO.net - VIX www.VIX.at
  Universitaetsstrasse 7, A-1010 Vienna,  Austria, Europe
  Tel: +43 1 4277 - 14078 (Fax: - 9140)       HM3550-RIPE